Differences between revisions 4 and 5
Revision 4 as of 2015-05-02 04:28:57
Size: 1000
Editor: AA6YQ
Comment:
Revision 5 as of 2015-05-02 04:43:57
Size: 1618
Editor: AA6YQ
Comment:
Deletions are marked like this. Additions are marked like this.
Line 3: Line 3:
An Electcraft K3 or KX3 can be directed to transmit CW, report decoded CW, transmit RTTY, and report decoded RTTY via CAT commands. Doing so requires both !WinWarbler and Commander to be running. An Electcraft K3 or KX3 can be directed to transmit CW, report decoded CW, transmit RTTY, and report decoded RTTY via CAT commands. Doing so requires both !WinWarbler and Commander to be running, with Commander [[TranceiverControlElecraft|configured to control an Elecraft K3 or KX3]].
Line 7: Line 7:
To configure @WinWarbler to transmit CW via CAT command, set the '''Keying''' panel on its Configuration window's '''CW''' Tab to {{{Xcvr Ctrl App}}}. To enable !WinWarbler to transmit CW via CAT command, set the '''Keying''' panel on the '''CW''' Tab of its Configuration window to ''Xcvr Ctrl App''.

To enable !WinWarbler to display CW decoded by a K3 or KX3,

 1. Configure your K3 or KX3 to decode CW, as described in the '''CW Text Decode Setup''' section of your owners manual

 1. In the '''Radio''' panel on the '''General''' tab of Commander's Configuration window, check the '''Convey decoded CW to WinWarbler''' box

 1. On the '''CW''' tab of !WinWarbler's Configuration window, check the '''display xmit/rcv characters''' box

 1. On !WinWarbler's Main window, set the '''Operating Mode''' panel to ''CW''

Configuring Command and WinWarbler for CW and RTTY Operation with an Elecraft K3 or KX3 using CAT Commands

An Electcraft K3 or KX3 can be directed to transmit CW, report decoded CW, transmit RTTY, and report decoded RTTY via CAT commands. Doing so requires both WinWarbler and Commander to be running, with Commander configured to control an Elecraft K3 or KX3.

Transmitting and Receiving CW

To enable WinWarbler to transmit CW via CAT command, set the Keying panel on the CW Tab of its Configuration window to Xcvr Ctrl App.

To enable WinWarbler to display CW decoded by a K3 or KX3,

  1. Configure your K3 or KX3 to decode CW, as described in the CW Text Decode Setup section of your owners manual

  2. In the Radio panel on the General tab of Commander's Configuration window, check the Convey decoded CW to WinWarbler box

  3. On the CW tab of WinWarbler's Configuration window, check the display xmit/rcv characters box

  4. On WinWarbler's Main window, set the Operating Mode panel to CW

Additional Topics


Post a question or suggestion on the DXLab reflector

Getting Started with DXLab

K3CWRTTYXcv (last edited 2018-10-24 02:51:07 by AA6YQ)