Differences between revisions 4 and 5
Revision 4 as of 2017-05-24 21:10:56
Size: 1488
Editor: AA6YQ
Comment:
Revision 5 as of 2017-05-24 21:12:19
Size: 1489
Editor: AA6YQ
Comment:
Deletions are marked like this. Additions are marked like this.
Line 3: Line 3:
With the '''Digital Mode Application''' panel set to ''WinWarbler'' on the Configuration window's Bandspread tab and [[Operation|WinWarbler]] running, clicking the callsign of a station in the Bandspread window that is operating in ''PSK31'', ''PSK63'', ''PSK125'', or ''RTTY'' will convey the entry's callsign, frequency, mode, and grid square to !WinWarbler, which will populate its '''QSO Info''' panel with this information and direct [[TransceiverControl|Commander]] to QSY your transceiver to the appropriate frequency and mode. With the '''Digital Mode Application''' panel set to ''!WinWarbler'' on the Configuration window's Bandspread tab and [[Operation|WinWarbler]] running, clicking the callsign of a station in the Bandspread window that is operating in ''PSK31'', ''PSK63'', ''PSK125'', or ''RTTY'' will convey the entry's callsign, frequency, mode, and grid square to !WinWarbler, which will populate its '''QSO Info''' panel with this information and direct [[TransceiverControl|Commander]] to QSY your transceiver to the appropriate frequency and mode.

Configuring Commander to Activate WinWarbler when the Callsign of a Station Operating in CW, SSB, AM, or FM is Clicked in the Bandspread Window

With the Digital Mode Application panel set to WinWarbler on the Configuration window's Bandspread tab and WinWarbler running, clicking the callsign of a station in the Bandspread window that is operating in PSK31, PSK63, PSK125, or RTTY will convey the entry's callsign, frequency, mode, and grid square to WinWarbler, which will populate its QSO Info panel with this information and direct Commander to QSY your transceiver to the appropriate frequency and mode.

If you want Commander to similarly activate WinWarbler when you click on the callsign of a station operating in CW, then in the Configuration window's Bandspread tab, click the CW mode panel's CW via DMA button. For similar action when you click on the callsign of a station operating in SSB, FM, or AM, check the Phone modes panel's SSB via DMA box, FM via DMA box, or AM via DMA box respectively.

Note that you can specify a Digital Mode Application other than WinWarbler, e.g.

  • MultiPSK
  • Fldigi-DXLabs Gateway


Post a question or suggestion on the DXLab reflector

Getting Started with Spot Collection

Getting Started with DXLab

CommanderActivationOnCWSSBBandspreadClick (last edited 2018-07-31 02:07:29 by AA6YQ)