This release - prevents an errorlog.txt file entry from being generated by SO2RModule.GenerateSO2RAux (tnx to Gary AB9M) - correctly executes a Command Sequence directive that specifies the slider's current value (tnx to Lou AC0X) - executes the Initial Command Sequence after sliders are initialized to their values from the previous operating session (tnx to Lou AC0X) - increases the number of commands per Command Sequence from 32 to 64 (tnx to Lou AC0X) - when controlling an Icom transceiver other than an IC-7800 and directed to enable split, selects the secondary VFO if "Dual Watch" is present and enabled; otherwise, selects the primary VFO (tnx to Bill G4WJS) - when controlling a TenTec Orion (tnx to Tom NY4I and Mike K9UW) *** indicates to other applications that the current transceiver is capable of sending CW via CAT command *** responds to directives from other applications to transmit CW text by directing the Orion to transmit this text *** responds to "set CW Speed" directives from other applications by directing the Orion to set its CW speed *** periodically directs the Orion to report its CW speed, and display the reported value in the Mode panel on Commander's Main window - provides support for the TenTec Argonaut VI (tnx to Jay W5JAY and John KI4JPL) - provides untested support for the Yaesu FTDX-3000 - in Commander's Messages window, provides the ability to send an arbitrary CAT command, and the ability to control Continuous Interrogation (tnx to Iain N6ML) - updates the CommandSequences.htm and MonitoringMessages.htm documentation files Commander 10.0.2 is available via the DXLab Launcher and via 73, Dave, AA6YQ