Differences between revisions 1 and 2
Revision 1 as of 2014-04-26 05:04:24
Size: 1056
Editor: AA6YQ
Comment:
Revision 2 as of 2014-04-26 05:08:46
Size: 1080
Editor: AA6YQ
Comment:
Deletions are marked like this. Additions are marked like this.
Line 5: Line 5:
By default, Windows 8 and Windows 8.1 will save an image of the operating system and currently hardware drivers to disk when they terminate. When next rebooted, this image is loaded from disk, yielding a quick startup compared to previous versions of Windows. However, if the reloaded image includes drivers for hardware that is no longer present or drivers that were to be replaced, a page fault or ''blue screen of death'' can ensue. By default, Windows 8 and Windows 8.1 will save a disk image of the operating system and current hardware drivers when they terminate. When next rebooted, this disk image is loaded, yielding a startup that is quick in comparison to previous versions of Windows. However, if the disk image includes drivers for hardware that is no longer present or drivers that were to be replaced, the result can be a page fault or Windows restart (''blue screen of death'').

Installing New Hardware in a Windows 8 System

de Joe W4TV

By default, Windows 8 and Windows 8.1 will save a disk image of the operating system and current hardware drivers when they terminate. When next rebooted, this disk image is loaded, yielding a startup that is quick in comparison to previous versions of Windows. However, if the disk image includes drivers for hardware that is no longer present or drivers that were to be replaced, the result can be a page fault or Windows restart (blue screen of death).

When installing new hardware in a system running Windows 8 or 8.1,

  1. disconnect any USB device(s) that are no longer needed
  2. depress the shift key while directing Windows to terminate
  3. if hardware installation or removal requires powering down the PC, do so -- but do not connect any new USB device(s) at this point
  4. restart Windows
  5. connect any new USB device(s)
  6. install new drivers if required


Transceiver Control

Getting Started with DXLab

Windows8NewHardware (last edited 2014-04-26 05:08:46 by AA6YQ)