Differences between revisions 7 and 8
Revision 7 as of 2012-02-21 01:53:29
Size: 1808
Editor: AA6YQ
Comment:
Revision 8 as of 2013-03-28 15:10:19
Size: 1812
Editor: localhost
Comment: converted to 1.6 markup
Deletions are marked like this. Additions are marked like this.
Line 5: Line 5:
 * An RS-232 connection between the !WinKey's serial port and a serial port on your PC; if necessary, you can [:ChangeAdaptorCOMPort: change the COM port number that Windows assigns to a USB-to-serial-port adaptor].  * An RS-232 connection between the !WinKey's serial port and a serial port on your PC; if necessary, you can [[ChangeAdaptorCOMPort| change the COM port number that Windows assigns to a USB-to-serial-port adaptor]].
Line 40: Line 40:
[:Multimode_Setup:Setting up CW, Phone, PSK, and RTTY Operation] [[Multimode_Setup|Setting up CW, Phone, PSK, and RTTY Operation]]
Line 42: Line 42:
[:Operation:Getting Started with CW, Phone, PSK, and RTTY Operation] [[Operation|Getting Started with CW, Phone, PSK, and RTTY Operation]]
Line 44: Line 44:
[:GettingStarted:Getting Started with DXLab] [[GettingStarted|Getting Started with DXLab]]

Controlling a WinKey

Required Connections

Configuring WinWarbler

On the Config window's CW tab,

  • set the Keying panel to WinKey, and set the port selector to the serial port on your PC to which your WinKey is connected

  • in the WinKey panel,

    • set the speed potentiometer sub-panel's minimum and maximum speeds (e.g. to 15 and 30 respectively)

    • select the speed potentiometer sub-panel's 2-wire or 3-wire button to match your WinKey's speed potentiometer wiring; see the WinKey manual for details.

    • in the timing sub-panel,

      • set the Farnsworth speed; to disable Farnsworth-style transmission, set this parameter to 0

      • set the dot/dash ratio to 50

      • set the first extension and compensation to 0; see the WinKey manual for details.

      • to generate a sidetone, enable the sidetone sub-panel and select the desired frequency

      • set the paddle sub-panel to reflect your choice of manual input; see the WinKey manual for details.

      • set the output port panel to reflect your WinKey's wiring; see the WinKey manual for details.


Setting up CW, Phone, PSK, and RTTY Operation

Getting Started with CW, Phone, PSK, and RTTY Operation

Getting Started with DXLab

WinKeyControl (last edited 2013-03-28 15:10:19 by localhost)