Differences between revisions 4 and 5
Revision 4 as of 2009-06-18 03:26:04
Size: 1666
Editor: AA6YQ
Comment:
Revision 5 as of 2009-06-18 03:27:24
Size: 1678
Editor: AA6YQ
Comment:
Deletions are marked like this. Additions are marked like this.
Line 18: Line 18:
   * set the '''speed potentiometer''' sub-panel's minimum and maximum speeds (e.g. to 15 and 30 respectively)    * set the '''speed potentiometer''' sub-panel's minimum and maximum speeds (e.g. to ''15'' and ''30'' respectively)
Line 24: Line 24:
      * set the '''Farnsworth speed'''; to disable Farnsworth-style transmission, set this parameter to 0       * set the '''Farnsworth speed'''; to disable Farnsworth-style transmission, set this parameter to ''0''
Line 26: Line 26:
      * set the '''dot/dash''' ration (e.g. to 75)       * set the '''dot/dash''' ratio to ''50''
Line 28: Line 28:
      * set the '''first extension''' and '''compensation''' to 0; see the !WinKey manual for details.       * set the '''first extension''' and '''compensation''' to ''0''; see the !WinKey manual for details.

Controlling a WinKey

Required Connections

  • An RS-232 connection between the WinKey's serial port and a serial port on your PC

  • A connection between the WinKey's straight key output and your transceiver's straight key input

Configuring WinWarbler

On the Config window's CW tab,

  • set the Keying panel to WinKey, and set the port selector to the serial port on your PC to which your WinKey is connected

  • in the WinKey panel,

    • set the speed potentiometer sub-panel's minimum and maximum speeds (e.g. to 15 and 30 respectively)

    • select the speed potentiometer sub-panel's 2-wire or 3-wire button to match your WinKey's speed potentiometer wiring; see the WinKey manual for details.

    • in the timing sub-panel,

      • set the Farnsworth speed; to disable Farnsworth-style transmission, set this parameter to 0

      • set the dot/dash ratio to 50

      • set the first extension and compensation to 0; see the WinKey manual for details.

      • to generate a sidetone, enable the sidetone sub-panel and select the desired frequency

      • set the paddle sub-panel to reflect your choice of manual input; see the WinKey manual for details.

      • set the output port panel to reflect your WinKey's wiring; see the WinKey manual for details.


[:Multimode_Setup:Setting up CW, Phone, PSK, and RTTY Operation]

[:Operation:Getting Started with CW, Phone, PSK, and RTTY Operation]

[:GettingStarted:Getting Started with DXLab]

WinKeyControl (last edited 2013-03-28 15:10:19 by localhost)