Differences between revisions 2 and 3
Revision 2 as of 2009-06-16 13:32:47
Size: 294
Editor: AA6YQ
Comment:
Revision 3 as of 2009-06-18 03:25:46
Size: 1665
Editor: AA6YQ
Comment:
Deletions are marked like this. Additions are marked like this.
Line 5: Line 5:
 * An RS-232 connection between the !WinKey's serial port and a serial port on your PC

 * A connection between the !WinKey's straight key output and your transceiver's straight key input

Line 6: Line 11:

On the '''Config''' window's '''CW''' tab,

 * set the '''Keying''' panel to '''WinKey''', and set the '''port''' selector to the serial port on your PC to which your !WinKey is connected

 * in the '''WinKey''' panel,

   * set the '''speed potentiometer''' sub-panel's minimum and maximum speeds (e.g. to 15 and 30 respectively)

   * select the '''speed potentiometer''' sub-panel's '''2-wire''' or '''3-wire''' button to match your !WinKey's speed potentiometer wiring; see the !WinKey manual for details.

   * in the '''timing''' sub-panel,

      * set the '''Farnsworth speed'''; to disable Farnsworth-style transmission, set this parameter to 0

      * set the '''dot/dash''' ration (e.g. to 75)

      * set the '''first extension''' and '''compensation''' to 0; see the !WinKey manual for details.

      * to generate a sidetone, enable the '''sidetone''' sub-panel and select the desired '''frequency'''

      * set the '''paddle''' sub-panel to reflect your choice of manual input; see the !WinKey manual for details.

      * set the '''output port''' panel to reflect your !WinKey's wiring; see the !WinKey manual for details.


Controlling a WinKey

Required Connections

  • An RS-232 connection between the WinKey's serial port and a serial port on your PC

  • A connection between the WinKey's straight key output and your transceiver's straight key input

Configuring WinWarbler

On the Config window's CW tab,

  • set the Keying panel to WinKey, and set the port selector to the serial port on your PC to which your WinKey is connected

  • in the WinKey panel,

    • set the speed potentiometer sub-panel's minimum and maximum speeds (e.g. to 15 and 30 respectively)

    • select the speed potentiometer sub-panel's 2-wire or 3-wire button to match your WinKey's speed potentiometer wiring; see the WinKey manual for details.

    • in the timing sub-panel,

      • set the Farnsworth speed; to disable Farnsworth-style transmission, set this parameter to 0

      • set the dot/dash ration (e.g. to 75)

      • set the first extension and compensation to 0; see the WinKey manual for details.

      • to generate a sidetone, enable the sidetone sub-panel and select the desired frequency

      • set the paddle sub-panel to reflect your choice of manual input; see the WinKey manual for details.

      • set the output port panel to reflect your WinKey's wiring; see the WinKey manual for details.


[:Multimode_Setup:Setting up CW, Phone, PSK, and RTTY Operation]

[:Operation:Getting Started with CW, Phone, PSK, and RTTY Operation]

[:GettingStarted:Getting Started with DXLab]

WinKeyControl (last edited 2013-03-28 15:10:19 by localhost)