Differences between revisions 2 and 7 (spanning 5 versions)
Revision 2 as of 2012-03-25 06:48:39
Size: 770
Editor: AA6YQ
Comment:
Revision 7 as of 2012-03-25 07:03:50
Size: 1580
Editor: AA6YQ
Comment:
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
=== Enabling Commander to interoperate with PowerSDR-IF and CW Skimmer === === Enabling Commander to interoperate with the PowerSDR-IF Panadapter and CW Skimmer ===
Line 4: Line 4:

This configuration provides simultaneous IF panadapter and [http://www.dxatlas.com/CwSkimmer CW Skimmer] functionality using WU2X's [http://www.wu2x.com/sdr.html PowerSDR-IF Stage panadapter].

 1. Using a [:ConnectedVirtualSerialPortPairs: Connected Virtual Serial Port Pair], connect CW Skimmer's '''CAT interface''' to PowerSDR-IF's '''CAT Control''' port

 1. Using a second [:ConnectedVirtualSerialPortPairs: Connected Virtual Serial Port Pair], connect PowerSDR-IF's '''IF Setup port''' to Commander's '''Secondary CAT Serial Port'''.

 1. Configure CW Skimmer's '''CAT interface''' for a '''Rig type''' of ''TS-2000'' and a '''Vaud rate''' of ''57600''

Configured in this way, CW Skimmer controls PowerSDR-IF, and PowerSDR-IF controls your Primary Transceiver via Commander.

Enabling Commander to interoperate with the PowerSDR-IF Panadapter and CW Skimmer

de Joe W4TV

This configuration provides simultaneous IF panadapter and [http://www.dxatlas.com/CwSkimmer CW Skimmer] functionality using WU2X's [http://www.wu2x.com/sdr.html PowerSDR-IF Stage panadapter].

  1. Using a [:ConnectedVirtualSerialPortPairs: Connected Virtual Serial Port Pair], connect CW Skimmer's CAT interface to PowerSDR-IF's CAT Control port

  2. Using a second [:ConnectedVirtualSerialPortPairs: Connected Virtual Serial Port Pair], connect PowerSDR-IF's IF Setup port to Commander's Secondary CAT Serial Port.

  3. Configure CW Skimmer's CAT interface for a Rig type of TS-2000 and a Vaud rate of 57600

Configured in this way, CW Skimmer controls PowerSDR-IF, and PowerSDR-IF controls your Primary Transceiver via Commander.

[http://www.dxlabsuite.com/Wiki/Graphics/Commander/K3SkimmerPanadapter.jpg]

Additional Topics

  • [:TransceiverControl:Getting Started with Transceiver Control]

  • [:TransceiverConnection:Connecting a Transceiver to a PC]

  • [:FrequencyControl:Changing Frequency]

  • [:ModeControl:Changing Mode]

  • [:Memories:Using Memories]

  • [:FrequencyDependentDevices:Using Frequency-dependent devices]

  • [http://www.dxlabsuite.com/commander/Help/CommandSequences.htm Using User-defined Command Sequences]


[http://groups.yahoo.com/group/dxlab/post Post a question or suggestion on the DXLab reflector]

[:GettingStarted:Getting Started with DXLab]

PowerSDRIFSkimmerCommander (last edited 2018-07-05 20:12:16 by AA6YQ)