Differences between revisions 23 and 24
Revision 23 as of 2016-05-05 02:58:33
Size: 2734
Editor: AA6YQ
Revision 24 as of 2016-05-05 02:59:07
Size: 2733
Editor: AA6YQ
Deletions are marked like this. Additions are marked like this.
Line 21: Line 21:
 1. an [[[K3CWRTTYXcv|Elecraft K3 or KX3]]  1. an [[K3CWRTTYXcv|Elecraft K3 or KX3]]

Operating in CW

Setting up for CW Transmission

  1. Setup the Transceiver-to-PC PTT (reception-transmission switching) connection

  2. Setup the CW Keying connection

  3. Configure WinWarbler for CW Operation

  4. Configure your transceiver
    1. set your transceiver frequency to an open CW band
    2. if Commander isn't running, set your transceiver's mode to CW

Setting up for CWDecoding

To display decoded CW, WinWarbler requires one of the following configurations:

  1. an Elecraft K3 or KX3

  2. an external HF modem (e.g. KAM 98, MFJ 464, PK232, PK900, and PTC-IIe)

  3. applications CWGet and CWGet to WinWarbler.

Main window in CW Mode

  • http://www.dxlabsuite.com/Wiki/Graphics/WinWarbler/CWMain.jpg

Operating CW

To transmit CW, on WinWarbler's Main window

  • set the WPM box to the desired speed in words per minute

  • click the Start button in the CW transmit panel

  • type the characters to be sent in the Main windows Transmit pane

  • click the Stop button in the CW transmit panel

Your transceiver should switch from reception to transmission, transmitted characters should appear in the Main window's Receive pane, and your transceiver should switch from transmission to reception after all characters have been sent. You can also transmit by constructing and invoking macros.

Decoding and display of received CW is only available via the use of an external modem, or via interoperation with CWGet.

Additional Information

Operating in CW, Phone, PSK, and RTTY

Getting Started with DXLab

CW_Operation (last edited 2019-06-12 15:48:28 by AA6YQ)