Differences between revisions 17 and 18
Revision 17 as of 2013-08-10 18:40:50
Size: 2551
Editor: AA6YQ
Comment:
Revision 18 as of 2014-06-21 20:44:39
Size: 2630
Editor: AA6YQ
Comment:
Deletions are marked like this. Additions are marked like this.
Line 52: Line 52:

  * [[CapturingDecodedInformation|Capturing Information from Decoded Data]]

Operating in CW

Setting up for CW Transmission

  1. Setup the Transceiver-to-PC PTT (reception-transmission switching) connection

  2. Setup the CW Keying connection

  3. Configure WinWarbler for CW Operation

  4. Configure your transceiver
    1. set your transceiver frequency to an open CW band
    2. if Commander isn't running, set your transceiver's mode to CW

Note: to display decoded CW, WinWarbler requires either an external HF modem (e.g. KAM 98, MFJ 464, PK232, PK900, and PTC-IIe) or the applications CWGet and CWGet to WinWarbler.

Main window in CW Mode

  • http://www.dxlabsuite.com/Wiki/Graphics/WinWarbler/CWMain.jpg

Operating CW

To transmit CW, on WinWarbler's Main window

  • set the WPM box to the desired speed in words per minute

  • click the Start button in the CW transmit panel

  • type the characters to be sent in the Main windows Transmit pane

  • click the Stop button in the CW transmit panel

Your transceiver should switch from reception to transmission, transmitted characters should appear in the Main window's Receive pane, and your transceiver should switch from transmission to reception after all characters have been sent. You can also transmit by constructing and invoking macros.

Decoding and display of received CW is only available via the use of an external modem, or via interoperation with CWGet.

Additional Information


Operating in CW, Phone, PSK, and RTTY

Getting Started with DXLab

CW_Operation (last edited 2019-06-12 15:48:28 by AA6YQ)