|Deletions are marked like this.||Additions are marked like this.|
|Line 17:||Line 17:|
|* verify that the default playback device is not muted or set to a low volume level||* verify that the default playback device is not muted or set to a low volume level; if you are using Vista or Windows 7, open the '''Windows Volume Mixer''' and make sure the '''Spotcollector'''' slider is at maximum (this slider will not appear until SpotCollector attempts to generate a sound).|
Configuring SpotCollector to Announce Incoming Spots
On the Configuration window's Audio tab,
Verify that SpotCollector's sound files have been installed, and that SpotCollector can direct the Windows default playback device to produce audible sounds
in the Audio Alarm panel, check the Enable box
if the Audio Alarm panel's Sound pathname box does not specify the file DX!.wave in SpotCollector's Sounds folder, click the Select button to the right of the Sound pathname box to display a standard Windows file selection window; use this window to select the file DX!.wave in SpotCollector's Sounds folder.
If SpotCollector's Sounds folder does not exist, or does not contain the file DX!.wave, you can obtain a complete set of announcement files by downloading and running [http://www.dxlabsuite.com/spotcollector/Announcements.exe]
click the Test button to the right of the Sound pathname box; you should hear the word DX announced; if you don't hear this announcement, then
- verify that Windows is configured to use the correct soundcard as its default playback device
verify that the default playback device is not muted or set to a low volume level; if you are using Vista or Windows 7, open the Windows Volume Mixer and make sure the Spotcollector' slider is at maximum (this slider will not appear until SpotCollector attempts to generate a sound).
- verify that speakers or headphones are properly connected to the default playback device, and that any external amplifier involved is powered and set to an appropriate volume level
If you want callsigns to be announced phonetically, verify that SpotCollector's phonetic announcement files have been installed by typing a callsign into the Callsign Announcement panel's Test callsign box, and then click the Test button to the right of this box
if the callsign is not announced phonetically, you can obtain a complete set of phonetics files by downloading and running [http://www.dxlabsuite.com/spotcollector/Phonetics.exe]
Allow the mouse cursor to hover over each of the boxes associated with the settings on the left side of the Audio Alarm panel below the Enable setting until a small window explaining the setting's function appears; based on this explanation, decide whether to enable or disable the setting
In the Alarm trigger panel, select the Filtered option; as you become more familiar with SpotCollector's audio announcements, you may wish to modify this setting later.
[http://groups.yahoo.com/group/dxlab/post Post a question or suggestion on the DXLab reflector]
[:CollectingSpots: Getting Started with Spot Collection]
[:GettingStarted:Getting Started with DXLab]