Differences between revisions 12 and 13
Revision 12 as of 2018-07-04 04:55:04
Size: 2691
Editor: AA6YQ
Comment:
Revision 13 as of 2023-06-06 16:43:11
Size: 2631
Editor: AA6YQ
Comment:
Deletions are marked like this. Additions are marked like this.
Line 16: Line 16:
  a. check the '''Continuous Frequency and Mode Interrogation box'''   a. check the '''Interrogation''' box
Line 18: Line 18:
  a. set the '''Continuous Frequency and Mode Interrogation interval''' to 200 ms   a. set the '''Interrogation interval''' to 200 ms

Getting Started with Alinco Transceiver Control

  1. connect your Alinco transceiver to your PC using an Alinco ERW-4C cable (or equivalent); if you use one of your PC's USB ports, configure Windows to not automatically power down this port.

  2. run Commander, and click the Config button on its Main window to open its Configuration window

  3. in Commander's Configuration window, select the General tab and then set the Radio panel's Model selector to DX-77T

  4. in Commander's Configuration window select the Ports tab and then

    1. designate the serial port that is connected to your radio interface

    2. select the baud rate, parity, word length, and stop bits that match your radio's settings

  5. on the Configuration window's General tab,
    1. check the Interrogation box

    2. set the Interrogation interval to 200 ms

  6. On Commander's Main window
    1. the VFO panel should reflect changes you make to your radio's frequency via its front panel

    2. the Mode panel should reflect changes you make to your radio's mode via its front panel

    3. Modifying the VFO panel's frequency display contents and striking the Enter key will radio's primary VFO to the specified frequency; see Changing Frequency for information about the other ways you can change transceiver frequency from the VFO panel

    4. Clicking the Mode panel's buttons should change your transceiver's mode; see Changing Mode for additional information

    5. Clicking the Bandspread button will display a Bandspread window; see Bandspread Window for additional information.

Additional Topics


Post a question or suggestion on the DXLab Discussion Group

Getting Started with DXLab

TranceiverControlAlinco (last edited 2023-06-06 16:43:11 by AA6YQ)