This release - correctly labels the Main window's VFO panels when an Omni VI is in split mode (tnx to Rich W3ZJ) - correctly implements the ALT VFO panel's Quick Split buttons for the Omni VI (tnx to Rich W3ZJ) - when Split is enabled for an Omni VI, displays the RX VFO in Commander's primary VFO panel and the TX VFO in Commander's secondary VFO panel (tnx to Rich W3ZJ) - correctly updates the Main window's VFO captions when performing an AxB with a Omni VI (tnx to Rich W3ZJ) - correctly updates the ALT VFO frequency made available to other applications( tnx to Rich W3ZJ) - correctly issues a User-defined Control Set's Initial Command Sequence when switching transceivers (tnx to Mike ON6ML) - if an Icom transceiver fails to respond to a command and "Verify CI-V command acceptance" is enabled, stops retrying after the specified limit (tnx to Jerry K3BZ) - ensures that responses to commands sent to a PW1 are not misinterpreted (tnx to Jerry K3BZ) - doesn't update the Radio Model registry setting unless it changes (tnx to Jerry K3BZ) - prevents an errorlog.txt entry from being generated when executing an initial command sequence that specifies a or command (tnx to Mike ON6ML) - when executing sliders after switching transceivers, ensures that each slider's restored value is "within range" (tnx to Mike ON6ML) - correctly updates the Main window's VFO captions when performing an AxB with a Icom transceiver (tnx to Jay W5JAY) - adds 115200 to all baud rate selectors (tnx to Ron WB2PKR) - polls the TenTec Omni VI for status and based on the response sets or clears Split (tnx to Rich W3ZJ) - accepts a command to give focus to the Bandspread window (tnx to Joe, W4TV) Commander 9.3.3 is available via the DXLab Launcher and via 73, Dave, AA6YQ